Insulating House & Roof Paint

Hy-Tech Ceramic Satin #200  is a 100% acrylic, house and roof paint with high performance quality similar to that of oil base industrial coatings.

A satin finish water base paint that is reinforced with our insulating ceramics which provides a thermal insulating barrier to the painted surface. This insulating ceramic paint will reduce your home's heating and cooling requirements saving you hundreds of dollars each year in reduced utility bills while providing a long lasting, self cleaning, paint finish.

Features:
Durable satin finish that is non-yellowing, colorfast and washable.
Resists moisture and salt spray
Fortified with Mildewcides
Hi hiding formulation
Alkali resistant,chemical resistant,chip and corrosion resistant
Low VOC compliant and contains No LEAD pigments
Environmentally Safe!

Uses:
Use on a wide variety of surfaces including metal siding, aluminum and wood siding, galvanized metal, drywall, plaster,wood trim, masonry, concrete block, stucco, storage tanks, wood and metal doors, cement roof tile, asphalt roof materials.

Hy-Tech Ceramic Satin   will give your home years of lasting, trouble free beauty.
Can be applied by brush, roller, conventional spray or airless spray.

Application: Two coats are recommended

Preparation:
Stir thoroughly before using! Be sure the surface is clean, dry, and free from grease or wax. All surface defects such as peeling, cracks and patches should be corrected before painting.
A coat of exterior wood primer is recommended on new wood and on staining type woods such as redwood, cedar, or mahogany.
Rusted metal surfaces should be primed with a good rust inhibiting primer prior to paint application.
Fresh plaster and stucco with a high lime content as well as all asphalt surfaces should first be coated with a latex sealer such as #10 Chalk Locker

Over old latex finish in good condition apply 2 coats at container consistency. Any patched areas and chalky surfaces should be primed.
Bare metal surfaces should be primed with Aqua Prime latex rust inhibiting metal primer. Aluminum siding and metal should be clean and free of chalking.
If slight thinning is necessary thin with water, not exceeding 1 pint per gallon or use our new Acri Flow the latex paint reducer that makes any paint more durable and easier to apply.

Clean up with soap and water. Allow 2 to 3 hours drying before re-coating.
Do not apply when surface temperature is below 50 deg. F.

We Supply the Solutions
You Just Need to Apply Them